Menu

CPCS A17 Telescopic Handler Training Northern Ireland

There are a number of activities involved with the CPCS A17 Telescopic Handler technical test at BSD Training Northern Ireland including;

1. Complete all manufacturers’ pre-start and running checks and prepare the forklift for travel
2. In a loaded and unloaded state;
a. Travel up and down the slope
b. Travel over rough terrain
c. Pass through a chicane executing full right and left turns in a forward and reverse direction
d. Stop and restart on the incline whilst loaded
3. With load 4 reverse with a load in a straight line for at least 20 metres and pass through a restriction at the end of the run
4. Prepare and set the tele-handler for each lift
5. Lift and place a load onto the tower. When placed, move the forklift away from the tower. Then retrieve the load, lower to ground level and place at a given point
6. Lift and place 3 x load 2 onto the truck bed. On completion, destack all of load 2 from the truck bed
7. Stack 3 x Load 2 vertically on top of one another. On completion de-stack and place alongside each other in a straight line
8. Lift load 3 and place at ground level at an indicated point using full reach (horizontal) of the telehandler
9. Carry out undercutting by both lifting and placing a load
10. All loads to be placed at ground level following completion of each activity
11. Configure the forklift for road travel
12. Park the tele-handler and carry out shut down and securing procedures

For more information please contact us on Tel; 02892639459 or info@bsdtraining.com

izmir escort bayan izmir escort bayan izmir escort bayan izmir escort bayan denizli escort bayan antalya escort antalya escort Antalya escort bayan Ankara escort ankara escort izmir escort bayan izmir escort bayan